Long Spigot

Long spigot fittings for pressurised gas and water supply

Long Spigot Fittings

Long Spigot Fittings are suitable for electrofusion and on-site butt-fusion without any additional pupping needed (provided that machines with narrow clamps are used).

Long Spigot fittings are available in SDR11 and SDR17/17.6, in sizes from 315mm to 630mm (dependent on fitting) and come in a wide range of shapes:

  • Reducers
  • Elbows
  • Equal Tees
  • Stub Flanges
  • Stub Flange Adaptor Kits
  • Reduced Branch Tees
  • Flanged Branch Tees
  • All Flanged Equal Tees
  • End Caps
  • 90°, 45°, 22½° and 11¼° Formed Bends
  • Stub Flange Assembly

Excellent Performance

  • No joints to fail in critical areas
  • No internal beads or corners to cause wear or solids build-up within the bend
  • Flow losses significantly reduced, due to the totally smooth bore and gradual change of direction

 Multiple Configurations

  • Can be formed to any angle.     
  • Bends can be formed to different radii
  • Compatible with GPS pipe and electrofusion couplers
  • Suitable for use with both electrofusion and butt-fusion installation techniques

Wish List

This product has been added to your requirements list. To check your requirements list, look under the left hand side navigation.

Once you have added all your products, you can print them all out in a list.